Table of Contents
Advertisement
10 Fixed Cycles: Multipass Milling ..... 253
10.1 Basics ..... 254
Overview ..... 254
10.2 RUN 3-D DATA (Cycle 30, DIN/ISO: G60) ..... 255
Cycle run ..... 255
Please note while programming: ..... 255
Cycle parameters ..... 256
10.3 MULTIPASS MILLING (Cycle 230, DIN/ISO: G230) ..... 257
Cycle run ..... 257
Please note while programming: ..... 257
Cycle parameters ..... 258
10.4 RULED SURFACE (Cycle 231, DIN/ISO: G231) ..... 259
Cycle run ..... 259
Please note while programming: ..... 260
Cycle parameters ..... 261
10.5 FACE MILLING (Cycle 232, DIN/ISO: G232) ..... 263
Cycle run ..... 263
Please note while programming: ..... 264
Cycle parameters ..... 265
10.6 Programming Examples ..... 268
30
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the ITNC 530 - CYCLE PROGRAMMING and is the answer not in the manual?
Questions and answers
Can I change the approach direction when cycle def a stud to avoid obstruction to the right
The provided context does not explicitly mention changing the approach direction to avoid obstruction. However, it describes selecting different axis configurations using the MOD function in the Programming and Editing mode. If modifying the axis configuration allows for adjusting the approach direction, it may be possible. Otherwise, specific cycle parameters should be checked in the programming manual.
This answer is automatically generated