HEIDENHAIN ITNC 530 - CYCLE PROGRAMMING User Manual page 332

Cycle programming
Table of Contents

Advertisement

Please note while programming:
Danger of collision!
You can now also use Cycle 403 when the "Tilt the
working plane" function is active. Ensure that the
clearance height is sufficiently large so that no collisions
can occur during the final positioning of the rotary axis.
The TNC does not check whether touch points and
compensation axis match. This can result in compensation
movements offset by 180°.
Before a cycle definition you must have programmed a
tool call to define the touch probe axis.
The order of the touch points influences the determined
compensation angle. Ensure that the coordinate of touch
point 1 in the axis perpendicular to the probing direction is
smaller than the coordinate of touch point 2.
The TNC stores the measured angle in parameter Q150.
332
Touch Probe Cycles: Automatic Measurement of Workpiece Misalignment

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Itnc 530Itnc 530 e

Table of Contents