Table of Contents
Advertisement
14 Touch Probe Cycles: Automatic Measurement of Workpiece Misalignment ..... 319
14.1 Fundamentals ..... 320
Overview ..... 320
Characteristics common to all touch probe cycles for measuring workpiece misalignment ..... 321
14.2 BASIC ROTATION (Cycle 400, DIN/ISO: G400) ..... 322
Cycle run ..... 322
Please note while programming: ..... 322
Cycle parameters ..... 323
14.3 BASIC ROTATION from Two Holes (Cycle 401, DIN/ISO: G401) ..... 325
Cycle run ..... 325
Please note while programming: ..... 325
Cycle parameters ..... 326
14.4 BASIC ROTATION over Two Studs (Cycle 402, DIN/ISO: G402) ..... 328
Cycle run ..... 328
Please note while programming: ..... 328
Cycle parameters ..... 329
14.5 BASIC ROTATION Compensation via Rotary Axis (Cycle 403, DIN/ISO: G403) ..... 331
Cycle run ..... 331
Please note while programming: ..... 332
Cycle parameters ..... 333
14.6 SET BASIC ROTATION (Cycle 404, DIN/ISO: G404) ..... 335
Cycle run ..... 335
Cycle parameters ..... 335
14.7 Compensating Workpiece Misalignment by Rotating the C Axis (Cycle 405, DIN/ISO: G405) ..... 336
Cycle run ..... 336
Please note while programming: ..... 337
Cycle parameters ..... 338
HEIDENHAIN iTNC 530
35
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the ITNC 530 - CYCLE PROGRAMMING and is the answer not in the manual?
Questions and answers
Can I change the approach direction when cycle def a stud to avoid obstruction to the right
The provided context does not explicitly mention changing the approach direction to avoid obstruction. However, it describes selecting different axis configurations using the MOD function in the Programming and Editing mode. If modifying the axis configuration allows for adjusting the approach direction, it may be possible. Otherwise, specific cycle parameters should be checked in the programming manual.
This answer is automatically generated