Table of Contents
Advertisement
11.3 DATUM Shift with Datum
Tables (Cycle 7, DIN/ISO: G53)
Effect
Datum tables are used for:
Frequently recurring machining sequences at various locations on
the workpiece
Frequent use of the same datum shift
Within a program, you can either program datum points directly in the
cycle definition or call them from a datum table.
Reset
Call a datum shift to the coordinates
X=0; Y=0 etc. from the datum table.
Execute a datum shift to the coordinates X=0, Y=0 etc. directly with
a cycle definition:
Use the TRANS DATUM RESET function.
Graphics
If you program a new BLK FORM after a datum shift, you can use
MP 7310 to determine whether the BLK FORM is referenced to the
current datum or to the original datum. Referencing a new BLK FORM
to the current datum enables you to display each part in a program in
which several pallets are machined.
Status displays
In the additional status display, the following data from the datum
table are shown:
Name and path of the active datum table
Active datum number
Comment from the DOC column of the active datum number
HEIDENHAIN iTNC 530
275
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the ITNC 530 - CYCLE PROGRAMMING and is the answer not in the manual?
Questions and answers
Can I change the approach direction when cycle def a stud to avoid obstruction to the right
The provided context does not explicitly mention changing the approach direction to avoid obstruction. However, it describes selecting different axis configurations using the MOD function in the Programming and Editing mode. If modifying the axis configuration allows for adjusting the approach direction, it may be possible. Otherwise, specific cycle parameters should be checked in the programming manual.
This answer is automatically generated