HEIDENHAIN ITNC 530 - CYCLE PROGRAMMING User Manual page 272

11.1 Fundamentals
Overview
Once a contour has been programmed, you can position it on the
workpiece at various locations and in different sizes through the use
of coordinate transformations. The TNC provides the following
coordinate transformation cycles:
Cycle
7 DATUM SHIFT
For shifting contours directly within the
program or from datum tables
247 DATUM SETTING
Datum setting during program run
8 MIRROR IMAGE
Mirroring contours
10 ROTATION
For rotating contours in the working
plane
11 SCALING FACTOR
For increasing or reducing the size of
contours
26 AXIS-SPECIFIC SCALING FACTOR
For increasing or reducing the size of
contours with scaling factors for each
axis
19 WORKING PLANE
Machining in tilted coordinate system on
machines with swivel heads and/or
rotary tables
272
Soft key Page
Page 274
Page 281
Page 282
Page 284
Page 286
Page 288
Page 290
Cycles: Coordinate Transformations