HEIDENHAIN ITNC 530 - CYCLE PROGRAMMING User Manual page 479

Log function
After running Cycle 451, the TNC creates a measuring log
(TCHPR451.TXT) containing the following information:
Creation date and time of the log
Path of the NC program from which the cycle was run
Mode used (0=Check/1=Optimize position/2=Optimize pose)
Active kinematic number
Entered calibration sphere radius
For each measured rotary axis:
Starting angle
End angle
Angle of incidence
Number of measuring points
Dispersion (standard deviation)
Maximum error
Angular error
Ascertained backlash
Averaged positioning error
Measuring circle radius
Compensation values in all axes (preset shift)
Evaluation of measuring points
Measurement uncertainty of rotary axes
HEIDENHAIN iTNC 530 479