Table of Contents
Advertisement
18 L Z+250 R0 FMAX M2
19 LBL 1
20 L X+0 Y+0 R0 FMAX
21 L Z+2 R0 FMAX M3
22 L Z-5 R0 F200
23 L X+30 RL
24 L IY+10
25 RND R5
26 L IX+20
27 L IX+10 IY-10
28 RND R5
29 L IX-10 IY-10
30 L IX-20
31 L IY+10
32 L X+0 Y+0 R0 F5000
33 L Z+20 R0 FMAX
34 LBL 0
35 END PGM COTRANS MM
300
Retract in the tool axis, end program
Subprogram 1
Define milling operation
Cycles: Coordinate Transformations
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the ITNC 530 - CYCLE PROGRAMMING and is the answer not in the manual?
Questions and answers
Can I change the approach direction when cycle def a stud to avoid obstruction to the right
The provided context does not explicitly mention changing the approach direction to avoid obstruction. However, it describes selecting different axis configurations using the MOD function in the Programming and Editing mode. If modifying the axis configuration allows for adjusting the approach direction, it may be possible. Otherwise, specific cycle parameters should be checked in the programming manual.
This answer is automatically generated