Table of Contents
Advertisement
15.10 DATUM CIRCLE CENTER (Cycle 416, DIN/ISO: G416) ..... 377
Cycle run ..... 377
Please note while programming: ..... 378
Cycle parameters ..... 378
15.11 DATUM IN TOUCH PROBE AXIS (Cycle 417, DIN/ISO: G417) ..... 381
Cycle run ..... 381
Please note while programming: ..... 381
Cycle parameters ..... 382
15.12 DATUM AT CENTER OF 4 HOLES (Cycle 418, DIN/ISO: G418) ..... 383
Cycle run ..... 383
Please note while programming: ..... 384
Cycle parameters ..... 384
15.13 DATUM IN ONE AXIS (Cycle 419, DIN/ISO: G419) ..... 387
Cycle run ..... 387
Please note while programming: ..... 387
Cycle parameters ..... 388
HEIDENHAIN iTNC 530
37
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the ITNC 530 - CYCLE PROGRAMMING and is the answer not in the manual?
Questions and answers
Can I change the approach direction when cycle def a stud to avoid obstruction to the right
The provided context does not explicitly mention changing the approach direction to avoid obstruction. However, it describes selecting different axis configurations using the MOD function in the Programming and Editing mode. If modifying the axis configuration allows for adjusting the approach direction, it may be possible. Otherwise, specific cycle parameters should be checked in the programming manual.
This answer is automatically generated