H3C LS-5100-16P-SI-OVS-H3 Configuration page 30

QACL
H3C Low-End Ethernet Switches Configuration Examples
Table 1-3 Configure ACL/QoS in port view
Configuration
Apply an ACL on a port
Configure the switch to
trust
received packets
Configure port-based rate
limit
Reference an ACL for
traffic identification, and
re-assign a priority to the
matching packets
Configure traffic policing
packet-filter { inbound |
outbound } acl-rule
the priority of
priority trust
line-rate { inbound |
outbound } target-rate
traffic-priority { inbound
| outbound } acl-rule
{ { dscp dscp-value |
ip-precedence
{ pre-value | from-cos } } |
cos
from-ipprec
local-precedence
pre-value }*
traffic-limit
acl-rule
[ exceed action ]
Command
{ pre-value |
} |
inbound
target-rate
1-4
Chapter 1 QACL Overview
Remarks
—
Configure the switch to
trust the priority carried in
received packets.
The granularity is
kbps. If an entered
number is in the range
N×64 to (N+1)×64 (N is a
natural number),
switch takes the value
(N+1)×64.
You can re-mark the IP
priority, 802.1p priority,
DSCP priority of packets,
and the priority of local
queues.
exceed action: specifies
the action taken on the
excess packets when the
packet traffic exceeds the
preset limit.
drop: Drop
excess packets.
remark-dscp value:
Re-set the DSCP
priority, and forward
the packets.
64
the
the