H3C LS-5100-16P-SI-OVS-H3 Configuration page 206

Multicast
H3C Low-End Ethernet Switches Configuration Examples
1) Configure description information for MSDP peers
Follow these steps to configure description information of an MSDP peer:
Enter system view
Enter MSDP view
Configure description
information for an
MSDP peer
2) Configure an MSDP mesh group
Follow these steps to configure an MSDP mesh group:
To do...
Enter system view
Enter MSDP view
Add an MSDP peer in a
mesh group
Note:
Before grouping multiple routers into an MSDP mesh group, make sure that these
routers are interconnected with one another.
To add different MSDP peers into an MSDP mesh group, configure the same mesh
group name on them.
An MSDP peer can belong to only one mesh group. A newly configured mesh group
name supersedes the existing one.
3) Configure MSDP peer connection control
Follow these steps to configure MSDP peer connection control:
Enter system view
Enter MSDP view
Shut down an MSDP peer
To do... Use the command...
system-view
msdp
peer peer-address
description text
Use the command...
system-view
msdp
peer peer-address
mesh-group name
To do...
system-view
msdp
shutdown peer-address
Chapter 1 Multicast Protocol Overview
—
—
Optional
No description information is
configured for MSDP peers by
default.
—
—
Required
An MSDP peer does not belong to
any mesh group by default.
Use the command...
1-15
Remarks
Remarks
Remarks
—
—
Optional
By default, MSDP peers
are connected.