H3C LS-5100-16P-SI-OVS-H3 Configuration page 204

Multicast
H3C Low-End Ethernet Switches Configuration Examples
Configure a C-BSR
Configure a C-RP
Configure a static RP
Configure a legal BSR
address range
Configure a legal C-RP
address range
Configure to filter the
register messages from
RP to DR
Disable RPT-to-SPT
switchover
Enter VLAN interface
view
Enable PIM-SM
Configuring a PIM-SM
domain boundary
Configure the hello
interval on the interface
To do...
c-bsr interface-type
interface-number
hash-mask-len [ priority ]
c-rp interface-type
interface-number
[ group-policy
acl-number | priority
priority ]*
static-rp rp-address
[ acl-number ]
bsr-policy acl-number
crp-policy acl-number
register-policy
acl-number
spt-switch-threshold
infinity [ group-policy
acl-number [ order
order-value ] ]
interface Vlan-interface
interface-number
pim sm
pim bsr-boundary
pim timer hello seconds
Chapter 1 Multicast Protocol Overview
Use the command...
1-13
Remarks
Optional
By default, no C-BSR is
configured. The default
priority is 0.
Optional
By default, no C-RP is
configured. The default
priority is 0.
Optional
No static RP is configured
by default.
Optional
No legal BSR address
range is configured by
default.
Optional
You can define the related
IP address ranges in an
ACL.
No legal C-RP address
range is configured by
default.
Optional
You can define the related
IP addresses in an ACL.
Disabled by default.
Optional
By default, the device
switches to the SPT
immediately after it
receives the first multicast
packet from the RPT.
—
Required
Optional
By default, no PIM-SM
domain boundary is
configured
Optional
The system default is 30
seconds.