H3C LS-5100-16P-SI-OVS-H3 Configuration page 121

Routing
H3C Low-End Ethernet Switches Configuration Examples
Configure a
large-scale BGP
network
I. Configuring Basic BGP Functions
Table 1-1 Configure basic BGP functions
Enter system view
Enable BGP and enter
BGP view
Specify the AS number for
the BGP peers
Assign a description
string for a BGP peer/a
BGP peer group
Activate a specified BGP
peer
Enable BGP logging
Specify the source
interface for route update
packets
Configuration task
Configuring BGP Peer
Group
Configuring BGP
Community
Configuring BGP RR
Configuring BGP
Confederation
Operation
system-view
bgp as-number
peer group-name
as-number as-number
peer { group-name |
ip-address } description
description-text
peer { group-name |
ip-address } enable
log-peer-change
peer { group-name |
ip-address }
connect-interface
interface-type
interface-number
Remarks
Required
Required
Optional
Optional
Command
1-19
Chapter 1 Routing Overview
Related
section
1.2.5 XI.
1.2.5 XII.
1.2.5 XIII.
1.2.5 XIV.
Description
—
Required
By default, BGP is
disabled.
By default, a peer is not
assigned an AS number.
Optional
By default, a peer/a peer
group is not assigned a
description string.
Optional
By default, a BGP peer is
active.
Optional
By default, BGP logging is
enabled.
Optional
By default, the source
interface of the optimal
route update packets is
used as the source
interface.