H3C LS-5100-16P-SI-OVS-H3 Configuration page 113

Routing
H3C Low-End Ethernet Switches Configuration Examples
Operation
Create and configure a
virtual link
III. Configuring the Network Type of an OSPF Interface
Table 1-23 Configure the network type of an OSPF interface
Enter system view
Enter interface view
Configure the network
type of the OSPF
interface
IV. Configuring an NBMA/P2MP Neighbor
Table 1-24 Configure NBMA/P2MP neighbor
Enter system view
Enter OSPF view
Configure an
NBMA/P2MP neighbor
V. Configuring the DR Priority on an OSPF Interface
Table 1-25 Configure the DR priority on an OSPF interface
Enter system view
vlink-peer router-id
[ hello seconds |
retransmit seconds |
trans-delay seconds |
dead seconds | simple
password | md5 keyid
key ] *
Operation
system-view
interface interface-type
interface-number
ospf network-type
{ broadcast | nbma |
p2mp [ unicast ] | p2p }
Operation
system-view
ospf [ process-id
[ router-id router-id ] ]
peer ip-address
[ dr-priority dr-priority ]
Operation
system-view
Command
Optional
For a virtual link to take
effect, you need to use this
command at both ends of the
virtual link and ensure
consistent configurations of
the hello, dead, and other
parameters at both ends.
Command
Command
Command
1-11
Chapter 1 Routing Overview
Remarks
Remarks
—
—
Optional
By default, the network
type of an interface
depends on the physical
interface.
Remarks
—
Required
Required
By default, the priority for
the neighbor of an NBMA
interface is 1.
Remarks
—