H3C LS-5100-16P-SI-OVS-H3 Configuration page 122

Routing
H3C Low-End Ethernet Switches Configuration Examples
Allow routers that belong
to non-directly connected
networks to establish
EBGP connections.
II. Importing Routes
Table 1-2 Import routes
Enter system view
Enable BGP, and enter
BGP view
Import the default route to
the BGP routing table
Import and advertise
routing information
generated by other
protocols.
Advertise network
segment routes to BGP
routing table
III. Configuring BGP Route Aggregation
Table 1-3 Configure BGP route aggregation
Enter system view
Enable BGP, and enter BGP
view
Operation
peer group-name
ebgp-max-hop
[ hop-count ]
Operation
system-view
bgp as-number
default-route imported
import-route protocol
[ process-id ] [ med
med-value | route-policy
route-policy-name ]*
network network-address
[ mask ] [route-policy
route-policy-name ]
Operation
Command
Command
Command
system-view
bgp as-number
1-20
Chapter 1 Routing Overview
Description
Optional
By default, routers that
belong to two non-directly
connected networks
cannot establish EBGP
connections.
You can configure the
maximum hops of EBGP
connection by specifying
the hop-count argument.
Description
—
—
Optional
By default, BGP does not
import default routes to
BGP routing table.
Required
By default, BGP does not
import nor advertise the
routing information
generated by other
protocols.
Optional
By default, BGP does not
advertise any network
segment routes.
Description
—
Required
By default, BGP is
disabled.