Routing
H3C Low-End Ethernet Switches Configuration Examples
Enable RIP on the
specified interface
II. Setting the RIP operating status on an interface
Table 1-6 Set the RIP operating status on an interface
Enter system view
Enter interface view
Enable the interface to
receive RIP update
packets
Enable the interface to
send RIP update packets
Enable the interface to
receive and send RIP
update packets
III. Specifying the RIP version on an interface
Table 1-7 Specify the RIP version on an interface
Enter system view
Enter interface view
Specify the version of the
RIP running on the
interface
IV. Setting the additional routing metrics of an interface
Additional metric is the metric added to the original metrics of RIP routes on an
interface. It does not directly change the metric value of a RIP route in the routing table
of a router, but will be added to incoming or outgoing RIP routes on the interface.
Operation
network
network-address
Operation
system-view
interface interface-type
interface-number
rip input
rip output
rip work
Operation
system-view
interface interface-type
interface-number
rip version { 1 | 2
[ broadcast | multicast ] }
Command
Command
Command
1-4
Chapter 1 Routing Overview
Remarks
Required
Disabled by default.
Remarks
—
—
Optional
By default, all interfaces
are allowed to send and
receive RIP update
packets.
Remarks
—
—
Optional
By default, the version of
the RIP running on an
interface is RIP-1.