Chapter 2 Configuration Examples; Configuration Examples; Static Routing Configuration Example - H3C LS-5100-16P-SI-OVS-H3 Configuration

Routing
H3C Low-End Ethernet Switches Configuration Examples

Chapter 2 Configuration Examples

Note:
The following configuration examples use the S5600 series switches.

2.1 Configuration Examples

2.1.1 Static Routing Configuration Example

I. Network requirements
1) Requirement analysis:
A small company requires any two nodes in its network communicate with each other.
The network should be simple and stable. The customer hopes to make the best use of
the existing devices that do not support dynamic routing protocols.
Based on the customer requirements and networking environment, configure static
routes to realize network interconnection.
2) Network diagram
Figure 2-1
Figure 2-1 Network diagram for static route configuration
shows the network diagram.
Chapter 2 Configuration Examples
2-1