Routing
H3C Low-End Ethernet Switches Configuration Examples
Device
Switch A
Switch C
Figure 2-2 Network diagram for RIP configuration
II. Configuration procedure
Note:
Only RIP-related configurations are described below. Before performing the following
configurations, make sure that the data link layer works normally and the IP addresses
of the VLAN interfaces have been configured.
1)
Configure Switch A.
# Configure RIP.
<SwitchA> system-view
[SwitchA] rip
[SwitchA-rip] network 110.11.2.0
[SwitchA-rip] network 155.10.1.0
2)
Configure Switch B.
# Configure RIP.
<SwitchB> system-view
[SwitchB] rip
[SwitchB-rip] network 196.38.165.0
[SwitchB-rip] network 110.11.2.0
3)
Configure Switch C.
# Configure RIP.
<SwitchC> system-view
[SwitchC] rip
Interface
IP Address
Vlan-int1
110.11.2.1/24
Vlan-int2
155.10.1.1/24
Vlan-int1
110.11.2.3/24
Vlan-int4
117.102.0.1/16
2-3
Chapter 2 Configuration Examples
Device
Interface
Switch B
Vlan-int1
Vlan-int3
IP Address
110.11.2.2/24
196.38.165.1/24