H3C LS-5100-16P-SI-OVS-H3 Configuration page 123

Routing
H3C Low-End Ethernet Switches Configuration Examples
Configure
BGP route
aggregation
IV. Enabling Default Route Advertising
Table 1-4 Enable default rout advertising
Enter system view
Enter BGP view
Enable default route
advertising
V. Configuring route reception filtering policies
Table 1-5 Configure route reception filtering policies
Enter system view
Enter BGP view
Configure the global route
reception filtering policy
Reference a routing policy
to filter routes from a
peer/peer group
Operation
Enable
automatic
route
aggregation
Enable
manual route
aggregation
Operation
system-view
bgp as-number
peer group-name
default-route-advertise
[ route-policy
route-policy-name ]
Operation
system-view
bgp as-number
filter-policy
{ acl-number | gateway
ip-prefix-name |
ip-prefix ip-prefix-name
[ gateway
ip-prefix-name ] }
import
peer { group-name |
ip-address }
route-policy
policy-name import
Command
summary
aggregate ip-address mask
[ as-set | attribute-policy
route-policy-name |
detail-suppressed |
origin-policy
route-policy-name |
suppress-policy
route-policy-name ]*
Command
Command
1-21
Chapter 1 Routing Overview
Description
Required
By default, routes
are not
aggregated.
Description
—
—
Required
By default, a BGP router
does not send default
routes to a specified
peer/peer group.
Description
—
—
Required
By default, the incoming
routing information is not
filtered.
Required
By default, no route filtering
policy is specified for a
peer/peer group.