Routing
H3C Low-End Ethernet Switches Configuration Examples
XIII. Configuring RIP-1 packet zero field check
Table 1-17 Configure RIP-1 packet zero field check
Enter system view
Enter RIP view
Enable the check of the
"must be zero" field in
RIP-1 packets
XIV. Setting RIP-2 packet authentication mode
Table 1-18 Set RIP-2 packet authentication mode
Operation
Enter system view
Enter interface
view
Set RIP-2 packet
authentication
mode
XV. Configuring RIP to unicast RIP packets
Table 1-19 Configure RIP to unicast RIP packets
Operation
Enter system view
Enter RIP view
Configure RIP to unicast
RIP packets
Operation
system-view
rip
checkzero
Command
system-view
interface
interface-type
interface-number
rip
authentication-mo
de { simple
password | md5
{ rfc2453 key-string
| rfc2082 key-string
key-id } }
system-view
rip
peer ip-address
Command
—
—
Required
If you specify to use MD5
authentication, you must specify one of
the following MD5 authentication types:
rfc2453 (this type supports the
packet format defined in RFC 2453)
rfc2082 (this type supports the
packet format defined in RFC 2082)
Command
—
—
Required
When RIP runs on the link that does
not support broadcast or multicast,
you must configure RIP to unicast
RIP packets.
1-8
Chapter 1 Routing Overview
Remarks
—
—
Required
Enabled by default.
Remarks
Remarks