Ruijie RG-RAP73Pro Cookbook page 65

Configuration Guide
5. Configuration Steps for Wired Pairing
Caution

Uplink device is an AP, EG router, or EGW router.

The new AP must be in factory status.

It can be scanned only when the live network is enabled with Mesh (see
details).
(1) Plug one end of the Ethernet cable to the uplink port of the new AP, and the other end to the downlink port of
an AP, EG router, or EGW router on the target network. Mesh networking takes one to three minutes. When
the system status LED is steady on, it indicates that Mesh networking finishes.
(2) Log in to the web interface of a device on the target network. In Network-Wide mode, choose Devices and
make sure that the new AP is online.
(3) Self-Healing Mesh is disabled by default. You need to enable it first (for details, see
Healing Mesh) to complete the wired-to-wireless handoff process.
(4) Unplug the Ethernet cable, power off the new AP, and install it as planned.
(5) Log in to the web interface of a device on the target network. In Network-Wide mode, choose Devices > AP.
Make sure that the new AP is online and the corresponding entry contains icon
Information column. The icon indicates that wireless backhaul is performed through the 5 GHz radio.
10
Network Monitoring
3.21 Enabling AP Mesh
4.12 Configuring Self-
in the Relay
for