Ruijie RG-RAP73Pro Cookbook page 208

Web-based Configuration Guide
Parameter
Encryption Protocol, Encrypted
Password
Caution

The security level of v3 users must be greater than or equal to that of the group.

There are three security levels, among which authentication and encryption requires the configuration of
authentication protocol, authentication password, encryption protocol, and encryption password.
Authentication but no encryption only requires the configuration of authentication protocol and encryption
protocol, while no authentication and encryption does not require any configuration.
5. Viewing v3 Device Identifier
Choose Network-Wide
Control > SNMP v3 Device Identifier List.
View the v3 device identifier in the SNMP v3 Device Identifier List pane.
6.5.4 SNMP Service Typical Configuration Examples
1. Configuring SNMP v2c

Application Scenario
You only need to monitor the device information, but do not need to set and deliver it. A third-party software can
be used to monitor the data of nodes like 1.3.6.1.2.1.1 if v2c version is configured.

Configuration Specification
According to the user's application scenario, the requirements are shown in the following table:
Description
Encryption protocols supported: DES/AES/AES192/AES256.
Encryption password: 8-31 characters. Chinese characters, full-width
characters, question marks, and spaces are not allowed.
It must contain at least three character categories, including uppercase
and lowercase letters, digits, and special characters.
Note: This parameter is mandatory when the security level is
authentication and encryption.
> Workspace > Network-Wide > SNMP > View/Group/Community/Client Access
153
System Settings