Ruijie RG-RAP73Pro Cookbook page 16

Installation Guide
2
Preparing for Installation
2.1 Safety Precautions
Note

To avoid personal injury and device damage, review the safety guidelines in this chapter before you
begin the installation.

The following safety precautions may not include all the potentially hazardous situations.
2.1.1 Safety Precautions

Do not expose the AP to high temperature, dusts, or harmful gases. Do not install the AP in an inflammable
or explosive environment. Keep the AP away from Electro-Magnetic Interference (EMI) sources such as large
radar stations, radio stations, and substations. Do not subject the AP to unstable voltage, vibration, and
noises.

The installation site should be dry. You are not advised to install the AP in a place near the sea. Keep the
device at least 500 meters (1,640.41 ft.) away from the ocean and do not face it towards the sea breeze.

The installation site should be free from water flooding, seepage, dripping, or condensation. The installation
site should be selected according to communication network planning and technical requirements for
communication equipment, and considerations such as climate, hydrology, geology, earthquake, electrical
power, and transportation.
Caution
Follow the installation instructions in the user manual to correctly install or remove the AP.
2.1.2 Handling Safety

After the AP is installed, avoid handling it frequently.

Turn off all power supplies and unplug all power cables before you handle the AP.
2.1.3 Electrical Safety
Warning

Improper or incorrect electric operations may cause a fire, electric shock, and other accidents, and lead
to severe and fatal personal injury and device damage.

Direct or indirect contact through wet objects with high voltage or mains power supply may be fatal.

Always observe the local regulations and standards. Only trained and qualified personnel should be allowed
to operate the AP.

Check potential risks in the work area, such as wet floor.

Find out the position of the indoor emergency power switch before installation. Cut off the power supply in
case of accidents.
8
Preparing for Installation