Ruijie RG-RAP73Pro Cookbook page 182

Web-based Configuration Guide

Stateless Address Autoconfiguration (SLAAC): The link local address is generated based on the interface ID,
and then the local address is automatically configured based on the prefix information contained in the route
advertisement packet.

Stateful address autoconfiguration, that is, DHCPv6: DHCPv6 is divided into the following two types:
○
DHCPv6 autoconfiguration: The DHCPv6 server automatically configures the IPv6 address/prefix and
other network configuration parameters.
○
DHCPv6 Prefix Delegation (PD): The lower-layer network device sends a prefix allocation application to
the upper-layer network device. The upper-layer network device assigns an appropriate address prefix
to the lower-layer device. The lower-layer device automatically subdivides the obtained prefix (generally
less than 64 bits in length) into subnet segments with 64-bit prefix length, and then advertises the
subdivided address prefixes to the user link directly connected to the IPv6 host through the route to
realize automatic address configuration of the host.
4.17.4 Enabling IPv6
Choose One-Device
Click Enable, and then click OK in the dialog box that appears to enable IPv6.
After IPv6 is enabled, you can configure the IPv6 addresses of WAN and LAN ports, view the DHCPv6 client,
and configure a static DHCPv6 address for the client.
> Config > Network > IPv6 Address.
127
Network Settings