Power Failures; Cc Mis Was Not Running; Cc Mis Was Running - Nortel CC MIS User Manual

Release 5.2
CC MIS Maintenance Guide

Power failures

The CC MIS system uses a Uninterruptable power supply (UPS) to re-
tain power during power failures. If a power failure exceeds the UPS
capability, then the CC MIS system must be powered down.
Note: When a power failure occurs, the user receives console messag-
es stating that the system will shutdown in "xx" minutes. These mes-
sages appear every two minutes until the count is down to zero
minutes. Afterwards, the system begins the shutdown process.

CC MIS was not running

If CC MIS was not running when the power failure occurred, perform
the steps in Step 4-4 (on the previous page) to power up CC MIS.

CC MIS was running

If CC MIS was running when the power failure occurred, perform the
step below to recover from the power failure.
Step 4-5: Recovering from a power fail-
1. Turn on power with the power button on the VME.
2. CC MIS will automatically restart.
ure
CC MIS
CC MIS
4-7