Nortel CC MIS User Manual page 83

Release 5.2
CC MIS Maintenance Guide
Perform the steps below to restore customer data from tape.
Step 5-5: Restoring customer data
1. Access the Backup and Restore Utilities menu.
2. Enter r to restore customer data. The system displays the Restore
screen.
Note: The Restore process for the configuration database cannot be
performed if any partitions are running. Restoration of a partition also
requires that partition be stopped. A prompt is displayed to shut
down the partition(s), as needed.
3. On the restore screen, identify the configuration database or partition
data to be restored. (Use the Options function key to display the Options
menu.)
4. Press the Commands function key to display the commands menu.
5. Select the Start Restore command. A pop-up dialog box appears that
may include the following messages:
Warning: the existing contents of each database being
Warning: restoring the configuration database with a different
Warning: restoring the configuration database will shutdown
Are you sure? (y/q)
6. Enter y to continue.
Note: Enter q to abort the restore process.
If you enter y, the following message appears:
Insert the tape and wait until the tape drive is ready. Press "y"
when ready, "q" to quit.
Ready? (y/q)
Note: Use the cartridge tape drive or the DAT drive, depending on your
system configuration and available disk size.
7. Enter y to restore data from tape. Enter q to abort the restore process.
restored will be removed immediately before
the database is restored from tape.
hardware configuration than the current system may
have undesirable results.
ALL partitions.
CC MIS
CC MIS
Continued on next
page ...
5-11