Nortel CC MIS User Manual page 215

Release 5.2
Systems with both DAT
and Cartridge tape drives
If your system has two tape
drives, the following mes-
sage is displayed when y is
entered in step 4.
This system has both a car-
tridge and a DAT tape drive.
The cartridge tape drive is the
larger of the two. Please select
the tape drive that contains the
CC MIS software upgrade as
follows:
c - Selects the CARTRIDGE
tape drive.
d - Selects the DAT tape drive.
Upgrade CC MIS from which
drive? (cartridge/dat/quit)
This prompt is displayed only
when the system has both a
CARTRIDGE and DAT tape
drives. If the system has only
one tape device, the prompt
is not displayed and no user
selection of the drive is
required.
Type c to select CAR-
TRIDGE tape or type d to
select the DAT tape drive.
Continue at step 5.
CC MIS Maintenance Guide
Step 11-1: Load new CC MIS soft-
ware version
1. Run a complete backup (refer to Chapter 5).
Note: If you are running Release 3.x under an earlier version of NTOS 2.x
(for example, 2.4) and you choose to install the latest version of NTOS 2.x
(for example 2.6), AFTER the backup is completed, you must perform the
following sub-steps prior to proceeding to step 2 in this procedure. The
sub-steps are as follows:
a. After the backup is completed, install the new NTOS 2.x version
(see Appendix C).
b. Re-Install your current Release 3.x.
c. Restore the backup Release 3.x data. (After the data is restored
and the Maintenance menu is displayed, proceed to step 2.)
2. Access the System Upgrade Utility Menu.
3. Enter l to load a new software release.
The system displays the following message:
Upgrade to a new version of CC MIS.
This option will perform the following actions:
- Shutdown CC MIS
- Install the new CC MIS software from the distribution tape
- Restart the CC MIS system
WARNING - It is strongly suggested that a full backup be
completed before doing a software upgrade.
To perform a backup, enter "n" at the following prompt, then
run an ad hoc backup from the Backup screen under the Backup
and Restore Utilities menu. Be sure to select all items for backup
and WAIT FOR THE BACKUP TO COMPLETE.
To continue with the upgrade and not perform backup, enter "y"
at the following prompt.
Do you wish to continue? (yes/no):
4. Enter y to continue with the procedure or press n if you want to quit the
software upgrade.
Note: If your system contains both the DAT and cartridge tape drives,
refer to the note in the margin.
5. The system displays the following message:
Please insert the tape containing the new CC MIS software. Please
wait until the tape drive is ready before answering.
Ready? (yes/quit)
CC MIS
CC MIS
Continued on next page...
11-3