Power Down Cc Mis - Nortel CC MIS User Manual

Release 5.2
The actual message displayed in Step 4 differs
slightly between platforms.
On the PowerPC platform the actual NOTICE
text is different than the text shown in this ex-
ample.
CC MIS Maintenance Guide

Power down CC MIS

This command powers down both CC MIS and the UNIX operating
system. You power down CC MIS when you want to stop running all
software or remove power from the system in order to service hard-
ware or move the system.
Perform the steps in below to power down CC MIS.
Step 4-3: Power down CC MIS
1. Access the Maintenance and Administration menu.
CC MIS shutdown
Advise supervisors that you are powering down the
CC MIS system. Supervisors do not have access to
CC MIS after you have powered down the system.
2. Enter r to display the Run State Utilities menu.
3. Enter d to power down the CC MIS system and the UNIX operating
system. The system displays the following warning:
Prepare the system for powering down.
This command shuts down the CC MIS system (if it is currently
running), then shuts down the operating system in preparation for
removing power from the system.
Ready (yes/quit)?
4. Enter y. (To quit and return to the menu, enter q.)
The system displays the following message:
CC MIS terminating ...
Beginning operating system shutdown.
SHUTDOWN started
Tues Apr6 14:11:40 CDT 1995
THE SYSTEM IS BEING SHUT DOWN NOW ! ! !
Log off now or risk your files being damaged.
NOTICE: System secured for powering down.
WAIT - corrupted files
After performing step 4, the user must wait for the message
NOTICE: System secured for powering down
before proceeding to step 5. Failure to wait may result in cor-
rupted files on the disk.
5. After the message NOTICE: System secured for powering down is
displayed, turn off power with the power button on the front of the VME.
6. Unplug power cord from the wall outlet or UPS. (Recommended)
CC MIS
CC MIS
4-5