Nortel CC MIS User Manual page 248

CC MIS
CC MIS
System Log Messages
SIGHUP: Hang-up signal received
The process received a hang-up signal. This log message should never occur. (Action Code: B)
SIGINT: Interrupt signal received
The process received an interrupt signal. This log message should never occur. (Action Code: B)
SIGILL: Illegal instruction
An illegal instruction was executed by the process. This log message should never occur. However, it could be
associated with memory problems, potential disk failure, or installation errors. (Action Code: A, E)
SIGFPE: Floating-point exception
An invalid floating point operation occurred. (Action Code: B)
SIGEMT: Unexpected signal
A process received an unexpected emulation trap signal. (Action Code: B)
SIGBUS: Bus error
A bus error occurred. This is typically generated by an invalid memory pointer but may also be generated by
faulty memory. (Action Code: B)
SIGSYS: Bad argument to system call
A system call was executed with invalid parameters. (Action Code: B)
SIGPIPE: Write to pipe with no read process
A write was issued to a IPC pipe but the reader process is no longer active. (Action Code: L)
SIGQUIT: Unexpected signal
A process received an unexpected signal to quit. (Action Code: L)
SIGTERM: Process terminated
This message is normally generated by processes as they are terminating. (Action Code: J)
SIGSEGV: Segmentation violation
This message may be generated due to an invalid memory pointer. It may also be generated due to hardware
problems. (Action Code: B)
SIGIOT: IOT trap
An I/O trap was received on an input or output operation. (Action Code: B)
SIGTRAP: Trace trap
This message is generated if processes are being traced. This signal should never occur. (Action Code: B)
Socket creation failed - type: AF_UNIX/STREAM
Indicates that the program was unable to create a new socket. The "other info" line may include additional infor-
mation. (Action Code: B)
B-8
Release 5.2
297-2671-545