Figure 7.6 Interval Configuration Screen - Nortel CC MIS User Manual

CC MIS
Release 5.2
Interval Configuration
The Interval Configuration screen is used to customize the intervals
used for each hour of the day. The Interval Configuration screen is ac-
cessed from the Storage Calculator screen (for local partitions) and
from the Partition Options menu (on NAPs). The Interval Configura-
tion screen is shown in the figure below.

Figure 7.6 Interval Configuration screen

Valid default values are 5, 10, 15, 30, and 60 minutes.
Valid interval lengths are 0, 5, 10, 15, 30, and 60. Leave the field blank
if you want to use the default setting.
Note: The size limit field is editable in this screen.
Issues Concerning Interval Lengths
1. If you are using the Networking feature, you should try to use the
same interval lengths on each partition. This allows for more concise
data reporting when requesting interval-based reports.
2. Using more frequent intervals (5, 10, and 15) will require more stor-
age disk space. Ensure that your system has adequate disk space to
store the requested interval data. Insufficient disk spaces results in
some data being discarded.
7-18 297-2671-545