Nortel CC MIS User Manual page 262

CC MIS
CC MIS
System Log Messages
Application resource shortage error - type: nnn
The switch is reporting an application resource shortage error of a type that is not recognized by the DSP. 'nn'
gives the unrecognized reason code contained in the error message. No action is taken by DMSLINK other than
reporting the error. (Action Code: Q)
Associate request received for unknown subpool "<subpool name>"
DMSLINK received a request from another process to associate itself with a subpool that is not in the configura-
tion information received from the switch. (Action Code: N)
Bad value in RO: rrrrrrr, field: ffffff, value: vvvvv
An illegal value has been detected in an RO received from the switch. "rrrrrr" identifies the type of RO, "ffffff"
gives the field within the RO, and "vvvvv" gives the illegal value. DMSLINK will attempt to continue regardless
of the error. (Action Code: S, B)
Connect confirmation on unknown circuit (ignored)
A connect confirmation was received on an unknown circuit. The confirmation message is ignored. (Action
Code: H)
Connect request received (ignored)
Received from the X.25 card a connect request. The connect request is ignored. (Action Code: H)
Data receive local failure on <x25 port>
The X.25 card returned an error on the X.25 port identified by <x25 port> following an attempt to receive data
from the port. (Action Code: AC, F, B)
Data received on unknown circuit (circuit closed)
Data was received on a circuit not currently in use. The data is ignored and a disconnect is issued to the circuit
reference. (Action Code: H)
Disconnect confirmation on unknown or closed circuit (ignored)
A disconnect confirmation was received on an unknown circuit. The confirmation message is ignored. (Action
Code: H)
Disconnect indication on unknown circuit (ignored)
A network disconnect was received with an invalid circuit reference number. The disconnect is ignored. (Action
Code: H)
Disconnect indication received on <x25 port>; cause=<cause>; code=<code>
The X.25 card has experienced a network disconnect on the X.25 port identified by <x25 port>. The clearing
cause is <cause> and the diagnostic code is <code>. (Action Code: F, I, S)
Dump in progress - LM request denied
This error indicates that a DMS image is currently being taken and all load management requests will be rejected.
This error condition is passed back to the CCLINK process in the response to its request. (Action Code: J)
B-22
Release 5.2
297-2671-545