Winserver Messages - Nortel CC MIS User Manual

CC MIS
CC MIS
System Log Messages

WINSERVER Messages

Introduction
This section contains error messages generated by the Windows Server Process of the CC MIS product. The CC MIS
product runs on a Down Stream Processor, hence the error messages will NOT APPEAR IN THE SWITCH LOG.
This section lists only those messages which are unique to the Windows Server Process. Messages listed in STAN-
DARD ERROR MESSAGES on page 1 may also be generated by this process.
Warning Messages
This section lists the warning messages that may be generated by WINSERVER. These messages usually indicate an
unusual condition that can be appropriately handled by the process, and which does not prevent the process from con-
tinuing execution.
Message checksum is invalid
A message was received with an invalid checksum. No action is required unless a large number of these errors
are generated. In this case, the quality of the serial connections should be increased. (Action Code: L, Y)
Message length field is invalid
A message was received with a corrupted length field. No action is required unless a large number of these errors
are generated. In this case, the quality of the serial connections should be increased. (Action Code: L, Y)
Received packet is too long
A packet was received that was greater than 4096 bytes in length. If the error occurs very infrequently, then it
could be due to transmission errors, otherwise it indicates a design error. (Action Code: L)
Acknowledgment timeout - session terminated
An acknowledgment for a transmitted message has not been received within the acknowledgment timeout period.
The Windows Server process is assuming that the link has been disconnected or the client process has terminated
and is terminating the current session. This log indicates that the system is automatically logging a supervisor off.
(Action Code: Y)
Poll timeout - session terminated
An acknowledgment for a periodic polling message has not been received within the poll timeout period. The
Windows Server process is assuming that the link has been disconnected or the client process has terminated and
is terminating the current session. This log indicates that the system is automatically logging a supervisor off.
(Action Code: Y)
Unable to create print spooler
A print spooler could not be created to support the addition of a Windows-based local printer to the system. Pre-
vious error logs should provide additional information on the cause of the error. (Action Code: L, B)
Unable to delete print spooler
The print spooler associated with a Windows-based local printer could not be deleted from the system. Previous
error logs should provide additional information on the cause of the error. (Action Code: L, B)
B-66
Release 5.2
297-2671-545