Nortel CC MIS User Manual page 259

Release 5.2
Partition table is full
Too many partition types were specified in the software configuration file. (Action Code; B)
Port table is full
Too many TCP ports were specified in the software configuration file. (Action Code; B)
Program table is full
Too many programs were specified in the software configuration file. (Action Code; B)
Record nnn in physical node table is invalid
Record number "nnn" in the physical node table which describes the nodes in the network could not be parsed.
(Action Code: B)
Transient program class table is full
The file which describes the software configuration of the system contains an invalid instruction. Specifically,
too many transient program classes were defined. (Action Code: B)
Unknown program "xxxxxx" associated with TCP port pppppp
The file which describes the software configuration of the system contains an invalid instruction. Specifically,
the program used to service a request on the TCP port named "pppppp" was not described in the PROGRAMS
section of the configuration file. (Action Code: B)
CC MIS Maintenance Guide
CC MIS
CC MIS
System Log Messages
(future)
B-19