Nortel CC MIS User Manual page 329

Release 5.2
Installing the AIX OS - continued
5. Enter the following command to boot from the tape (substitute the address determined in step 4 for
the <addr> parameter):
Occasionally the "pboot" command will fail if the tape is not yet ready to be read. In this case, wait
a few seconds and try the command again.
6. Once the boot command has been issued the following should appear on the terminal:
A delay of approximately 90 seconds occurs at this point while the system boots a minimal operating
system in order to begin the installation. Eventually, the following screen will appear:
CC MIS Maintenance Guide
pboot 0 <addr> (eg. pboot 0 50)
Booting from: NCR53C825, Controller 0. Drive 50
Device Name : /pci@80000000/pci1000,3@c,0/tape@5,0
Loading: Operating System
IPL Loaded at: $03C51000
Residual-Data Located at: $03F7F000
CC MIS
CC MIS
Installing the operating system
Continued on next page ...
C-7