Figure 9.13 Link Trace Screen (Multiple Links) - Nortel CC MIS User Manual

Release 5.2
CC MIS Maintenance Guide
Link trace
The Link Trace command is used to capture the messages that are be-
ing sent between the ACD switch and the CC MIS system for debug-
ging purposes. The output from Link Trace is a useful diagnostic tool
when trying to determine the interactions between the ACD switch
and the down stream processor.
The Link Trace command can capture the initializa-
tion data received from the host switch in a Link
Note:
Trace file. When Link Trace is started and stopped,
the on or off state is written to a file that CC MIS
can check upon startup. If Link Trace is on when
CC MIS is started, the system can immediately be-
gin the Link Trace and the initialization data is cap-
tured and can be analyzed.
The figure below shows the Link Trace screen. A prompt is displayed
to allow the user to specify the link for which tracing is desired.

Figure 9.13 Link Trace screen (multiple links)

The commands listed on the Link Trace screen re-
late to the link displayed the title.
Note:
When multiple links have been defined, a prompt is displayed request-
ing selection of the link on which the link trace commands are to op-
erate.
CC MIS
CC MIS
9-27