Shut Down The Cc Mis Application - Nortel CC MIS User Manual

Shutdown, startup, reboot, and power down

Shut down the CC MIS application

The Shutdown the CC MIS Application command shuts down the CC MIS
application, leaving the operating system, non-CC MIS programs, and
CC MIS maintenance software running.
Note: To shut down both the CC MIS software and the Linux operating
system, use the Power Down the System command.
If you request a maintenance function that can only be performed with
CC MIS shut down, the maintenance and administration software
automatically shuts down CC MIS. You do not need to shut down the
system manually.
An exception is when you change the the Network Name, which requires
manual shutdown.
Perform the steps in Procedure 17 on page 165 to manually shut down
CC MIS.
ATTENTION
164
Advise supervisors that you are shutting down the CC MIS
application. Supervisors do not have access to CC MIS
after you shut down the system. CC MIS supervisors are
automatically logged off if you shut down the CC MIS
system.
Call Center Management Information System
Standard 2.0