Lift Interface Commands - urmet domus iPercom 1060 Installation And User Manual

7.2.11 L
IFT INTERFACE COMMANDS
If in the IPerCom system there are one or more Lift Interfaces, it is possible to enable the lifts so that the
resident or non-resident can reach the desired floor or apartment according to the operating mode (set
on the staircase node) where the concerned Lift Interface is positioned. Press the "Lift interface
commands" item to do this. The following message will appear:
To enable the lift, select the block, stair, and floor (or apartment) on the left side of the screen (marked
"Topological code") that the resident (or non-resident) wants to reach. On the right side of the screen
(marked "Activation time") you can choose the time for which the lift remains enabled to reach a
specific floor or apartment. The "ACTIVATE" and "DEACTIVATE" buttons activate and deactivate the
previously selected time.
The selection of the floor or apartment in the left part of the previous figure depends on the
operating mode of the Lift Interface (if floor or apartment mode). For more details see
technical manual for the
On the Lifts Interface configuration page, it is necessary to add the switchboard path to choose
the floors and apartments. For more details see
94
Figure 86: lift interface commands
installer.
the system technical manual for the
the system
installer.
DS1060-121G