Door Lock Release Commands; Door Opening - urmet domus iPercom 1060 Installation And User Manual

6.8 D
OOR LOCK RELEASE COMMANDS
6.8.1 D
OOR OPENING
System electric locks can be activated from Switchboard application interface by clicking on button
(14) to open the pedestrian door and on button
The activation of these electric locks normally is allowed only during the call phase from a calling station
to switchboard (in detail during the ringing and communication time): the operator can activate only the
electric locks of the calling station, which has called the switchboard.
To activate electric locks out of the call phase, see paragraph
Switchboard application interface can show also the door status by means of icon
starts blinking if the door (pedestrian) is left open since a time greater than the time set in the
configurator (for further information see
Clicking on this icon, the following window appears, where information on opened doors is shown:
The door status of Call Modules 1060/12-13-17-18-23, Entry Panels 1060/71-74-75-78, Entry
Panels 1060/21-33-34, Key Readers 1060/86, and Modular Calling Station with 1060/48 can only
be displayed if a specific door sensor has been connected to their terminals (magnetic micro
contacts or equivalent).
Door status is displayed on all Switchboards of the system, also on Switchboards that are not of
competence for devices, which have created the warning.
For more information on doors left open, see
42
(15) to open gate.
the system technical manual for the
Figure 29: display of doors left opened
Opened doors.
Door opener.
installer).
(19): this icon
DS1060-121G