urmet domus iPercom 1060 Installation And User Manual page 154

C ( )
ONFIGURATION OF THE SYSTEM AND PARAMETERS OF THE CALL FORWARDING FUNCTION INSTALLER
Using the IPerCom Installer Tools application, the installer creates the project and the related
configuration, that is defines the system topology, adds the devices on the topological nodes, assigns
appropriate names to the devices, apartments, and topological nodes, creates the address books, the
users, and activations, configure the parameters of the call forwarding function in the "System" section
of the configurator (as shown below):
Figure 143: call forwarding parameters in tab "System"
In correspondence with "Call Forwarding" item, check that the value is set to "Enabled", as shown in the
figure above.
In correspondence with the "Call Forwarding Cloud URI" item, it is necessary to set the server on which
the user is registered via the CallMe app: the default server is "sip.urmet.com", while the server
"sip.urmet.cn" is to be used only for the Chinese market.
The "Call forwarding quality" item must be set based on the available bandwidth: if you encounter
problems in the call, such as jerky video and/or incomprehensible audio, it is best to lower the quality of
call forwarding call.
The "CallMe Manager Support" item must be enabled to configure the call forwarding function with the
CallMe Manager app.
After creating the configuration, it is necessary to apply it to the system. To do this, you must first save
the configuration and exit the configurator. Then select the "Configuration" tab and press the "Apply
changes" button to transfer the configuration to the system:
154 DS1060-121G