Switchboard Application Network Setting Change; Case 1: Manual Network Settings Previous Setting Automatic - urmet domus iPercom 1060 Installation And User Manual

8.3 S
WITCHBOARD APPLICATION NETWORK SETTING CHANGE
It is necessary to identify 4 cases depending on what set on Configurator in section "Network settings"
(for further information see
types: manual or automatic.
8.3.1 C 1: M
ASE ANUAL NETWORK SETTINGS
It is necessary in this case setting manually Switchboard application network parameters: IP address,
subnet mask, default gateway and DNS server. Application shows the following pop-up window in 5
minutes, after network settings was changed:
According to the image above:
• item "Required configuration" shows network parameters to set manually to Switchboard
application;
• item "Current configuration" shows that previous network configuration had an automatic
addressing with DHCP.
140
the system technical manual for the
(
PREVIOUS SETTING
Figure 133: from automatic to manual network settings
installer). Network settings can be of 2
: )
AUTOMATIC
DS1060-121G