urmet domus iPercom 1060 Installation And User Manual page 136

D
ISPLAYING AND RESETTING THE ALARMS ASSOCIATED WITH THE INPUTS OF
If an alarm is generated through the input of a Relay Actuator, the
highlighted in red. Press the icon in question with the mouse button to display an item containing:
• a significant icon of the alarm type;
• the name of the input that generated the alarm.
Press the icon in question with the mouse button to be transferred to the map where the input of the
Relay Actuator that generated the alarm is located, as shown below:
The button allows resetting the alarm using (for example) the "Reset Alarm - Gas" item:
In fact, if this item is pressed, the alarm is reset, i.e. the
(if there are no other alarms in progress).
The "Reset Alarm - Gas" item resets the alarm both on the maps and on the corresponding alarm
window of the Switchboard application.
The default icon for the inputs of a Relay Actuator is as follows:
input positioning on the maps using the
In APPENDIX B: Alarm signal and door left open icons on maps
with the alarms that can be generated through the inputs of a Relay Actuator.
136
Figure 128: actuator relay input in alarm
Figure 129: type of alarm on Relay Actuator input
button.
R A
ELAY CTUATORS
icon starts flashing and is
icon on the maps will no longer flash
. It can be changed during the
there is a list of icons associated
DS1060-121G