Functions to Backup the Controller's Setting Data
Uploading unit configuration file from
the SD card
26
6.
Use
and
to select
7.
Press
.
8.
Use
and
to select
[Save unit configuration on the SD card] .
9.
Press
.
ð The configuration is now saved, which takes approx. 3
minutes.
10.
Then press
.
11.
You can now remove the SD card and process the file, if nec‐
essary, or simply leave the file on the SD card.
The configuration entered was accidentally
overwritten
if a configuration file is stored on an SD card
and another configuration file is uploaded,
then the existing configuration file is renamed
CONFIG.BAK
the name CONFIG.BIN . If you wish to reuse
CONFIG.BAK
CONFIG.BIN
CONFIG.BIN
uration file.
Different identity codes
If the identity codes of the source and destination
controller differ, only the settings that both control‐
lers have in common are carried over.
If you have copied a configuration file to an SD card using the
[Copy unit configuration file onto SD card] , then you can use this
function to upload the unit configuration file from the SD card into a
DACa controller or transfer it to another DACa controller (cloning).
To do this, the source and destination controller must have an
identical identity code. This function saves you the work involved in
manually setting up the unit configuration. Always check whether
you can use the settings for your intended application.
1.
There needs to be an SD card with a CONFIG directory and a
valid CONFIG.BIN file in the controller's reader.
2.
Press
3.
Use
and
to select
4.
Press
.
5.
Use
and
to select
6.
Press
.
7.
Use
and
to select
8.
Press
.
9.
Use
and
to select
[Upload unit configuration file from the SD card] .
10.
Press
.
ð The configuration now uploads, which can take around 1
minute.
[Upload or save unit configuration] .
. The new configuration file has
, then you have to delete
and rename CONFIG.BAK as
. You can now reuse the config‐
[Setup] .
[Extended configuration] .
[Upload or save unit configuration] .
Need help?
Do you have a question about the DULCOMETER diaLog DACb and is the answer not in the manual?