Setting Measured Variables - ProMinent DULCOMETER diaLog DACb Assembly And Operating Instructions Manual

Setting measured variables

11 Setting measured variables
Tab. 17: You can set the following measured variables on the controller:
Measured variable
[none]
[pH [mV]]
[pH [mA]]
[ORP [mV]]
[ORP [mA]]
[mA general]
64
User qualification: trained user
n
tion' on page 16
Continuous display ➨
[Measurement] ➨
[Measured variable]
Measuring channel settings
This descriptions of [Channel 1] apply correspond‐
ingly to the settings in all other measuring chan‐
nels. The procedure for entering the settings for
the channel in question is identical, however the
parameters to be set may differ. Your attention is
drawn to the differences, which are also described.
Channel 1
Measured variable
Sensor type
Measuring range
Temperature
Process temperature
pH compensation
Fig. 35: Setting measured variables, using the example of
[Channel 1] and the measured variable [Chlorine].
Meaning
The controller does not perform a measure‐
ment.
pH sensor with mV signal
pH sensor with mA signal
ORP sensor with mV signal
ORP sensor with mA signal
Ä Chapter 2.4 'User qualifica‐
[Measurement] ➨
➨
[Meas. channel 1]
or
.
Unit
[pH]
[pH]
[mV]
[mV]
[Freely selectable]
n
[%]
n
[mA]
n
[m]
n
[bar]
n
[psi]
n
[m 3 /h]
n
[gal/h]
n
[ppm]
n
[%RH]
n
[NTU]
n
➨ or
Chlorine
CLE3/CLE3.1
0... 2.0 ppm
Manual
10.0 °C
Off
A1082