Setting The [Pumps]; Setting [Pump 1] - ProMinent DULCOMETER diaLog DACb Assembly And Operating Instructions Manual

[Pumps]
Setting the
16 Setting the
16.1

Setting [Pump 1]

138
[Pumps]
User qualification: trained user, see
n
fication' on page 16
Continuous display ➨
Measuring channel settings
This descriptions of [Channel 1] apply correspond‐
ingly to the settings in all other measuring chan‐
nels. The procedure for entering the settings for
the channel in question is identical, however the
parameters to be set may differ. Your attention is
drawn to the differences, which are also described.
Pumps
Pump 1 channel 1
Pump 2 channel 1
Pump 3 channel 2
Pump 4 channel 2
Fig. 102: Setting the [Pumps]
Setting [Pump 1] or [Pump 2]
Only the process for[ Pump 1] is described. The
set-up process for [Pump 2], [Pump 3] or [Pump 4]
is the same as for [Pump 1].
CAUTION!
Refer to the operating manual for the pump
Possibility of damaging the pump. Faults in the
process.
–
–
–
–
[Pumps] ➨
➨ or
[External Contact] operating
Set the pump to
status
Observe the maximum stroke rate for the pump
Switch off any stored stroke settings in the
pump control
The maximum stroke rate for the pump can be
found in the pump operating manual
– Setting a stroke rate on the controller,
which is higher than the pump's actual pos‐
sible maximum stroke rate, can lead to
hazardous operating statuses
Ä Chapter 2.4 'User quali‐
[Pumps]
A1064