Configuring Canvas Decoders - Extron electronics NAVigator User Manual

TIP:
Each canvas has a Canvas ID (see figure 76,
need to reference a canvas from a control system, the canvas ID does not change, even if you have
renamed the canvas.
7. Click SAVE ( ) to save all changes or CANCEL (
6

Configuring canvas decoders

Configure all decoders in a canvas at once, so that they have the same settings, as follows:
1. If necessary, click the Menu icon ( , see
2. If necessary, click WINDOWALLS (see
3. If necessary, click the existing canvas to configure (
(see figure 77).
A A A A A A A A A A A A A A A A A A
B B B B B B B B B B B B B B B B B B
Figure 77. Configuring Canvas Decoders
4. If necessary, click and drag the right scroll bar (
5. Make the following decoder adjustments, as necessary:
TIP: An asterisk (
changes.
a. Click the Resolution drop-down list (
the canvas to the desired output resolution.
b. Click the Refresh Rate drop-down list (
canvas.
figure 9,
figure 75,
2 2 2 2 2 2 2 2 2 2 2 2 2 2 2 2 2 2
3 3 3 3 3 3 3 3 3 3 3 3 3 3 3 3 3 3
4 4 4 4 4 4 4 4 4 4 4 4 4 4 4 4 4 4
5 5 5 5 5 5 5 5 5 5 5 5 5 5 5 5 5 5
6 6 6 6 6 6 6 6 6 6 6 6 6 6 6 6 6 6
7 7 7 7 7 7 7 7 7 7 7 7 7 7 7 7 7 7
8 8 8 8 8 8 8 8 8 8 8 8 8 8 8 8 8 8
) appears next to the CONFIGURATION tab to indicate that there are unsaved
A
) to select among the resolutions presented to scale all outputs in
3
4
on page 74) that identifies that canvas. If you
E
) to abandon them.
7
on page 11).
1
on page 73).
1
or ). The Canvas CONFIGURATION pane opens
3 4
9 9 9 9 9 9 9 9 9 9 9 9 9 9 9 9 9 9 ¢ ¢ ¢ ¢ ¢ ¢ ¢ ¢ ¢ ¢ ¢ ¢ ¢ ¢ ¢ ¢ ¢ ¢
) to reveal the Display Settings adjustments (
1
) to select among the available rates for all outputs in the
NAVigator System Manager • HTML Operation
1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1
).
2
75