Extron electronics NAVigator User Manual page 105

Resetting the NAVigator
Reset the NAVigator settings or reboot the unit as follows:
1. If necessary, click the Menu icon (see figure 99,
1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1
2 2 2 2 2 2 2 2 2 2 2 2 2 2 2 2 2 2
Figure 99. Opening the Restore Configuration Page
2. If necessary, click TOOLS > Device Tools (
3. If necessary, click RESET (
4. Select (click) the desired reset mode (
NOTES:
• Reset Device Settings (Retains TCP/IP Settings and Password) — Resets configuration settings.
All communication settings and the password are retained. See the
configuration settings on page 92.
• Reset All Settings and Delete Files (Retains TCP/IP Settings) — Resets configuration settings
except the communication settings, which are maintained. Resets the password to the default, which
is extron. See the
• Reset All Settings and Delete Files — This reset is identical to the Full Factory reset (see the
of rear panel reset modes on page 8).
5. Click APPLY (
).
6
The NAVigator reports that it is Resetting and displays a status bar that shows the
progress of the reset operation. When the operation completes, the NAVigator
reboots.
NOTE: To continue to operate the NAVigator, you must reconnect (see
Pages on page 9).
1
4 4 4 4 4 4 4 4 4 4 4 4 4 4 4 4 4 4
4 4 4 4 4 4 4 4 4 4 4 4 4 4 4 4 4 4
4 4 4 4 4 4 4 4 4 4 4 4 4 4 4 4 4 4
5 5 5 5 5 5 5 5 5 5 5 5 5 5 5 5 5 5
6 6 6 6 6 6 6 6 6 6 6 6 6 6 6 6 6 6
). The Device Tools page opens.
2
).
3
) or Reboot (
4
table
of communication and configuration settings.
).
).
5
Opening the Embedded HTML
NAVigator System Manager • HTML Operation
3 3 3 3 3 3 3 3 3 3 3 3 3 3 3 3 3 3
table
of communication and
table
95