Installing The Processor Heatsink Assembly - HPE ProLiant DL180 Gen10 User Manual

CAUTION: If installing a processor with a faster speed, update the system ROM before installing the processor.
To download firmware and view installation instructions, see the Hewlett Packard Enterprise Support Center
website.
CAUTION: THE CONTACTS ARE VERY FRAGILE AND EASILY DAMAGED. To avoid damage to the socket or
processor, do not touch the contacts.
CAUTION: To prevent mechanical damage or depositing oil on your hands or other contaminant to the heatsink
contact surface, hold the heatsink only by the edge of its base plate. Do not touch the heatsink fins.
IMPORTANT: Existing HPE ProLiant and HPE Synergy Gen10 server products containing first-generation Intel
Xeon Scalable processors may not be upgraded to second-generation Intel Xeon Scalable processors at this time.
For more information, see the product QuickSpecs on the Hewlett Packard Enterprise website (https://
www.hpe.com/info/qs).

Installing the processor heatsink assembly

Prerequisites
Before installing this option, ensure that you have the following:
• The components included with the hardware option kit
• T-30 Torx screwdriver
Procedure
1. Identify the processor, heatsink, and socket module components.
2. Review the processor cautions.
3. If installed, remove the front bezel.
4. Power down the server.
5.
Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
6.
Disconnect all peripheral cables from the server.
7. Do one of the following:
Extend the server from the rack.
•
• Remove the server from the rack.
8. Remove the access panel.
9. Remove the air baffle.
10. Install the processor heatsink assembly:
Hardware options installation
77