Table of Contents
Advertisement
Installing the serial port
Prerequisites
Before you perform this procedure, make sure that you have a nut driver.
Procedure
1.
Power down the server.
2.
Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3.
Disconnect all peripheral cables from the server.
4.
Do one of the following:
Extend the server from the rack.
•
Remove the server from the rack.
•
5.
Remove the access panel.
6.
Do one of the following:
•
Remove the secondary riser blank.
•
If installed, remove the expansion board.
7.
Install the serial port on the rear of the chassis.
Hardware options installation
87
Advertisement
Table of Contents
