Installing The Serial Port Option - HPE ProLiant DL20 Gen10 Plus User Manual

Installing the serial port option

Installing the serial port option
CAUTION: CAUTION:
A discharge of static electricity from a finger or other conductor might damage system boards or other static-sensitive
devices. To prevent damage, observe antistatic precautions.
CAUTION: CAUTION:
The port blank provides EMI shielding and helps maintain proper thermal status inside the server. Do not operate the
server when a port blank is removed without the corresponding I/O port option installed.
Prerequisites Prerequisites
Before you perform this procedure, make sure that you have the following items available:
Hex screwdriver
Spudger or any small prying tool
Procedure Procedure
1. If physically powering down a server with the front bezel installed, remove the front bezel .
2. Power down the server.
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Disconnect all peripheral cables from the server.
5. Remove the server from the rack .
6. Place the server on a flat, level work surface.
7. Remove the access panel .
8. Remove the riser cage.
9. Remove the serial port blank:
a. Detach the right side of the blank (callout 1).
b. Repeat step a on the left side to remove the blank (callout 2).
Retain the blank for future use.
10. Install the serial port:
a. Insert the serial port into the rear panel opening (callout 1).
b. Install the hex screws (callout 2).
Installing the serial port option 150