Installing A Rear Serial Port Interface - HPE ProLiant DL380 Gen10 Plus User Manual

Installing a rear serial port interface

Installing a rear serial port interface
Prerequisites Prerequisites
Before you perform this procedure, make sure that you have the following items available:
The components included with the hardware option kit
Procedure Procedure
1. Power down the server.
2. Do one of the following:
Disconnect each power cord from the power source.
Disconnect each power cord from the server.
3. Do one of the following:
Extend the server from the rack .
Remove the server from the rack .
4. Remove the access panel .
5. Remove the serial port blank.
6. Install the serial port interface.
7. Connect the cable to the system board.
Installing a rear serial port interface 193