Installing The Rear 2-Bay Sff Drive Cage - HPE ProLiant DL180 Gen10 User Manual

14. Install the air baffle.
15. Install the access panel.
16. Install the server into the rack.
17. Connect all peripheral cables to the server.
18. Connect each power cord to the server.
19. Connect each power cord to the power source.
20. Power up the server.
21. If removed, install the front bezel.
The installation is complete.

Installing the rear 2-bay SFF drive cage

Prerequisites
Before you perform this procedure, make sure that you have a T-15 Torx screwdriver available.
Procedure
1. Power down the server.
2.
Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3.
Disconnect all peripheral cables from the server.
4. Remove the server from the rack.
5. To access side screws of rear 2-bay SFF drive cage, remove the left inner rail.
6. Remove the access panel.
Hardware options installation
57